Note: In order to use PoE Passthrough on the Secondary port, a 24V, 1A PoE adapter is required. This Gigabit Ethernet port provides passthrough PoE to power and connect a 24V passive PoE device to the network. ![]() Alternatively, the device may be reset remotely via a Reset button located on the bottom of the Gigabit PoE Adapter. To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. This Gigabit Ethernet port is used to connect the power and should be connected to the LAN and DHCP server. The ETH-SP will absorb power surges and safely discharge them into the ground. We recommend that you use two Ethernet Surge Protectors, model ETH-SP, one near the NanoBeam and the other at the entry point to the building. Surge protection should be used for all outdoor installations. ![]() For more details, visit ui.com/toughcable We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. ![]() Shielded Category 5 (or above) cabling with drain wire should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE.Wall-mounting: wall fastener (not included).Pole-mounting: 7 mm socket wrench or screwdriver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |